Brother HL-2250DN toner light stuck – easy fix

My toner light stays on even after I change my toner. Fortunately, there is a way to reset it. Switch your printer off. Open front cover and keep it open. Press „Go“ button and hold it while turning printer on. Hold “Go” until „toner“, „drum“ and „error“ light stays on. Then press „Go“ button twice and wait again until „toner“, „drum“ and „error“ lights stay … Continue reading Brother HL-2250DN toner light stuck – easy fix

Increase upload size limit in WordPress when using WAMP

If you installed your WordPress site on WAMP, you can not upload pictures or documents larger than 2 MB by default. You can’t change this limit in WordPress backend, don’t bother searching for it. Instead, go to your server (or computer) where WAMP is installed and run it. You need to adjust PHP parameter „upload_max_filesize“. Luckily, WAMP makes that incredibly easy. Click on its icon … Continue reading Increase upload size limit in WordPress when using WAMP

Netlogon.log, where is it, how to enable it

If you need to troubleshoot network authentication or communication issues on Windows computer, netlogon service can provide useful log, but it must be enabled first. How do I enable netlogon service logging Open Comand Prompt as an administrator and use following command: Nltest /DBFlag:2080FFFF Where do I find the log file Every netlogon-related activity should now be writen in “%windir%\debug\netlogon.log”.(usually C:\windows\debug\netlogon.log) If nothing shows up … Continue reading Netlogon.log, where is it, how to enable it

Enable and disable STP on HP switch

If you are like me and just need to know how to switch spanning-tree protocol on or off and struggle to google simple answer, I hope you found this article. Connect to cli. You can find out if spanning-tree protocol is enabled or disabled by using this command: show span Enable STP config spanning-tree write-memory Disable STP config no spanning-tree write-memory Continue reading Enable and disable STP on HP switch

Warface: Tips for playing medic in PVP

Here are some tips I gathered over the years playing as medic. Who to revive first When you see two or more of your teammates dead on the ground, always check if one of them is medic and revive him/her first. The resurrected medic can immediately revive another teammate. If you can’t tell who is medic by appearance, look for red circle on the body, … Continue reading Warface: Tips for playing medic in PVP